www.hho4free.com Start-up shows A lot more HHO is produced using closer spacing & only 1 neutral. You will see more HHO gas being produced because of it. (25 amps) The center tube is 1 1 inches, the next tube is 1 3/4 inches, and the outer tube is 2 inches; each of these tubes are 12 inches long. I could construct this tube with one or two inside tubes, and run straight water, no electolites. The HHO output would be the same, using less current, but, and a BIG but – the current would eat away at the positive tube. It would look like it has been sandblasted in a matter of weeks. Not good. Running a cell off of straight water is nice, but it causes unbelievable dammage over time. Try it and see. The outside container is 4 inches in diameter and 17 inches long. I chose this size to experiment with because it provided the best flexability for reconstructing the inside tubes. Today, I am more inclined to think a 3 inch outer tube is sufficient. I think it is important for you to have a least 1 liter/quart of water over the top of your cell. You won’t have to check your water level as often. You can add sensors to monitor the water level and replinish it; but I prefer the more personal touch (I want to know what is going on under that lid?). Visit my channel to get details of all of my videos. It will be a learning experience. www.youtube.com
